Wizard1956 is NO LONGER MIA!!!!!

Good luck wizard!

 O U C H!

Wiz...I'm rootin' for you! I remember this past summer/fall when he moved back and was trying to get everything set up correctly.

Cp is right....ouch!

I miss you, Wiz! Call if you can.

May the wizard's own good fortune that he bestows upon us all visit him in this time of technical downturn! Good luck, my friend!

Sounds like the bio battery died. With power lights, fans running with HD indicator light blinking even so much so... it seems it will not boot due to no bio being set. Thus I would check the battery and/or try another one. Then check to see if there is power at the four wire connection for the cpu power plug. With other lights showing it kind of says the board is getting power. But then again how much. Be worth a try to have that power supply tested. But I do not think that is at the root of the cause yet.

The other bad part is that the board got a bit too hot and either the cpu is fried or the chipset has done about the same. Check to see if the heat sink for the chipset is getting warm to the touch. If it fried it will more likely not get hot. Cpu is harder to determine without doing other test on the board.

I'd start with that bio battery and then go to check the power supply. From there you can about figure where it is and another thing to see is ... are there any pci slots used by graphics or sound cards. If so remove them and try to reboot. They will short out - but usually cause the power supply to shut down when they do and nothing usually works. Start by unplugging hardware and trying to startup. It could be something simple too like the Hard drive bought it. Even if it did you should be able to disconnect it and see a bio startup. That would be step in a good direction. Check all the hardware one at a time HD, DVD/CD, floppy, and whatever maybe added to it. Next even remove the memory to see if it boots. It will start with no memory and the bio will give you a warning. So that would be great.

Try to figure it better and get back to us here Red Neck! I hope it is something simple. Plus what kind of rig is it?{Specs}

Aaaah of all the people to happen to, it couldn't have happend to a nicer bloke, I feel so sorry for yer Wiz, I wish I could help, I have a coupla spare parts here that you could use, but alas no way of getting them to you, I wish I could afford to send them to you...shit...shit...shit...I hate swearing in public, but things like this jsut bum me out, I bet they would be tons of people that could give you the parts you need, but again no way of getting them to you......computer get well soon....to Wiz, I am awful sorry mate, really awful sorry...hope you get sorted soon mate, we need you here...cheers the Thug

PM me his computer specs and his address and phone #.

Compaq Model PC SR5110NX   Build Date 4/2007     Purchase Date  11/2007

Home Basic Vista   512 MB Ram, onboard graphics.

Upgraded to  Vista Ultimate     2GB HS RAM    ATI Radeon HD 2400 Pro graphics card.

Upgrades made in Feb. 2009

Working fine until now...CPU temp  usually between 86 and 95 degrees F.

IBM CRT Monitor

Just reinstalled OS.

He can't see a Bios screen because the PC won't turn the monitor on. 

I think Yrag is on duty, but no news yet.       

how many times i told to u guys .... shut down the pc while u r sleeping .... it usually traits hehehehehehehhe

Jim, spoke with the Wiz....weirdo problem, but I hope it's only the power supply....yrag is the go to man...he can make 'puters wag their tails. Shame it had to give out on him, though.

I see that he upgraded his memory from 512mb to 2GB in February. Did he test his memory? It sounds to me like this could be a case of bad memory.

I gave him the memory from my PC because I upgraded to 4 GB. It was working fine here, and worked there for a few months. But ya never know, it could go bad.

I'm sure you've thought about this but he could drop the old stuff back in and see if it will boot. He could also pull the new video card out and plug into the onboard video and see if it will boot then.

For an old guy his memory seemed ok to me....

Wizard has asked me to thank everyone for their advice and condolences. Especially Yrag, RedneckDude and Doc.  He wants you to know that his PC is DOA in it's present state, but will be undergoing surgery soon and will hopefully come out of recovery in a week or so. If not, he's only a quarter mile away from the cemetery.

OK Red Neck I'm sitting here gripping my chair for some kind of results...

Thanks for the info on that rig. So this is a AMD processor? With an ATI graphics card?

He acn take the graphics card out and use the on board graphics. Plus it will or should start without any memory in it. Start meaning it will show the HP boot bio screen with options to enter the bio settings.

But if that board has a bad cpu or chipset it may not do none of the above. SoI await what Yrag has to find with this.

Like I said I'm gripping my chair arms in haste of some news here!

-------------------------------------------- edited -----------------------------------------------

Well that shoulds bad and good. Least now I can relax a bit. Had me really going there.

Wizard is one of my better friends and I'd of done almost anything to help him out.

Even got an ole HP laptop here with XP Pro on it he could have. Got 1gig of ram and 160 gig HD.

But seems Yrag has it worked out for now. But if things change just send me an email to my address listed here with my profile and I'll see what I can do for him ASAP.

Bullshit....there's nothin' a good ass kickin' won't fix.....

He's up.

Way to go Gary

After trying everything yrag suggested,we were consigned to repairing it.After cleaning the inside of the case I decided to unplug everything on the mobo and reconnect it. I didn't find anything loose so I suspect this served to reset things and its's all good to go now.

Your advice may have been right on the money,Shelbygt_the_Car! Btw, I think WC is the greatest community on the planet.

LOL....on your new thread I suggested...p.s. maybe it's an intermittant loose connection. Still could be. Happy to have you back! yrag for President.

AWESOME !   My tester is back!    

Glad to see your back up and running.